Our slasher decks have been engineer designed and certified here in Australia for use with small to medium sized tractors. These decks are manufactured by us here at our factory in Kilcoy.

The slasher decks are folded from a single piece of sheet steel to assist with minimising welds as well as keep the slasher's construction simple yet effective.

The decks are available in 3mm, 4mm and 5mm plate and fitted with 10mm skids and a "floating" headstock.

All linkages are Cat 1.

All components are sourced from Bare-Co in Australia.

The standard gear box fitted is 40HP but larger gear boxes are available if required.

A slip clutch and PTO shaft are included as standard.

The cutter bar holds 2 step down blades.

The following is a list of the major components and parts numbers used.

The specs for these can be obtained from the Bare-Co website at bareco.com.au. (When you visit the website just click on any picture and the parts catalogue will appear).

Parts Used: 40HP Gear box B2666 Slip clutch B4164 Slip clutch safety cover AS8209

PTO shaft AB 4075 Blades B6002 Head stock top pin B75 Head stock bottom pin B2593

Page 2